EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

Joe Miller
  • Male
  • Bloomington, IL
  • United States
Share on Facebook

Joe Miller's Friends

  • Darrell Schneider
  • Bill Liers
  • Kent King

Joe Miller's Discussions

WTB Allwave 12 Power Supply/Amp

Started this discussion. Last reply by Joe Miller Aug 7. 4 Replies

I need an  AW12 power supply.  As it turns out I have two AW12 two dial power supplies so I might be willing to trade one for the AW12 single dial version.Thanks,JoeContinue

Can Anyone ID this Scott Speaker

Started this discussion. Last reply by Joe Miller May 11. 7 Replies

I thought this was a Masterpiece Speaker.  It has the 8 pin plug and it is wired like the Masterpiece schematic shows except for pin 7 which is connected to ground rather than to the 4th terminal…Continue

Scott AC10 Questions

Started this discussion. Last reply by Joe Miller Apr 27. 6 Replies

Hi all,I am trying to get my AC10 in its best possible operating condition and have a few questions:1.  The left hand knob is a trimmer capacitor which works great when tuning, but it is spring…Continue

Why different Scott Coils

Started this discussion. Last reply by Joe Miller Apr 11. 5 Replies

I have a full set of Scott coils but the pin configuration does not fit my AW12 2 dial. I understand Scott produced various configurations of coils:1. Why?2. How many different configurations were…Continue

Gifts Received


Joe Miller has not received any gifts yet

Give a Gift


Joe Miller's Page

Joe Miller's Blog

Philly Amp wiring

Posted on July 20, 2016 at 9:57pm 1 Comment

I am working on a Philly amp and am finding a number of wiring mods that deviate from the schematic. Some are due to someone bypassing a bad audio transformer and for adding a second phone plug input with volume/mixing pots.

But I also found a 125 ohm Candohm type resistor that is factory mounted to the side of the amp chassis. It is connected in series to the cap connected to pin 6 of the set plug socket and then tied to ground. It doesn't show on the schematics that I…


Comment Wall

  • No comments yet!

You need to be a member of EH Scott Radio Enthusiasts to add comments!

Join EH Scott Radio Enthusiasts


© 2017   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service