The Fine Things are Always Hand Made
Harley's Discussions
Info on a Scott 16
Started this discussion. Last reply by David C. Poland Sep 7, 2019. 19 Replies 0 Likes
Hello all!I'm new to the group but I have recently acquired a scott 16 in fantastic shape and a scott phantom deluxe in not so great shape. I can find alot of info on my phantom deluxe but barely…Continue
Harley's Page
Latest Activity
"The later production Model 16's have a hum adjustment pot on the amp near the rectifier tubes."
"I "scan the bands" periodically with mine and also listen to some AM broadcasts on. They are excellent radios. Eventually I'll get my Acousticraft cabinet restored so that I can get the radio and speaker in their proper…"
"Well last night I finished the last few .05 caps, the 2 MFD can, and the can with the 4 .5 caps in it. Sensitivity is just amazing with this set and my wavemagnet antenna. There was a slight hum that wouldnt go away until reading about…"
"yes - 465 KC per Scott documentation.
Select INFO ARCHIVE at top of this page, then select SET FOLDERS, and select 16-18 (for the model 16).
Review and/or print the Service Manual. If you don't have the owner's instruction manual, print it…"
"I am not sure if my post actually worked, but I got my Model16 up and running, just needs alignment.Serial # JJ-176, Acoustacraft also, same cabinet as my Phantom.
Is the I F frequency 465kc?
Thanks
Next is the Allwave I have with a great…"
"Hi all, this is Tom , northern California. I also have Scotts, a Phantom, a model 16, and an Allwave. The Phantom is all done and works well except a hum that I need to find. I just finished the Model16 and am ready to align it. Is it also 465kc for…"
"What is the serial number of your set? I'd like to add it to the data we have. Thanks!
Kent"
"Thank you guys for all the help! Luckily my OT seems to be ok. I rarely come across Scott sets and usually when I do its just a chassis so I couldn't pass up this console when I found it! This thing is one of my favorite…"
"I measured my original belt and then ordered 3 around that length and found the 8.8" to work perfectly. Hopefully it will work for yours as well.
My output transformer had been replace with some universal transformer that, no doubt…"
"Yes on the 4 caps @ .5 mfd. 2 @ 200 volts and 2 @ 400 volts. The metal box is ground.
I cut the wires near the box. Used Dremel tool to cut the box open on one side. Melted out the contents (messy).
I just used 630 volt film caps @ .47 mfd.…"
"If you look at the schematic, you'll see 4 .5 mfd caps around the 1st AF. According to the photos I took of mine during disassembly, these are the 4 caps that are in the can. I used all 630 volt, .47 mfd film caps."
Harley's Photos
© 2024 Created by Kent King.
Powered by
