EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

Joe Miller's Discussions (239)

View

Discussions Replied To (197)	Replies	Latest Activity
"The only discrepancy I have found so far in my restore is the one noted previously o…" Joe Miller replied Dec 23, 2014 to Mods to Phillys	57	Jan 19, 2015 Reply by Y2K Bruce
"Hi guys, Just found time to get back to this. Bill, thanks for the schematic, mine…" Joe Miller replied Dec 22, 2014 to Mods to Phillys	57	Jan 19, 2015 Reply by Y2K Bruce
"Hi Bill, On pin 3, I have a .05 mf (connected to ground) and a 2 Meg resistor (I did…" Joe Miller replied Dec 22, 2014 to Mods to Phillys	57	Jan 19, 2015 Reply by Y2K Bruce
"Making progress on the restore. Yes, I have the additional components connected to…" Joe Miller replied Dec 17, 2014 to Mods to Phillys	57	Jan 19, 2015 Reply by Y2K Bruce
"Okay, If I run across any other deviations, I will point them out on this thread so…" Joe Miller replied Dec 16, 2014 to Mods to Phillys	57	Jan 19, 2015 Reply by Y2K Bruce
"Thanks Norm, I installed a 680 ohm resistor and the bypass cap to make the set match…" Joe Miller replied Dec 16, 2014 to Mods to Phillys	57	Jan 19, 2015 Reply by Y2K Bruce
"David, Thanks for all the great tips. I got the dial glass off without breaking it.…" Joe Miller replied Dec 10, 2014 to Philharmonic Factory Wiring Error?	30	Dec 10, 2014 Reply by Joe Miller
"Hi David, Yes, I think the intent was to wire the resistors as a voltage divider to…" Joe Miller replied Dec 10, 2014 to Philharmonic Factory Wiring Error?	30	Dec 10, 2014 Reply by Joe Miller
"Yep, thanks. " Joe Miller replied Dec 6, 2014 to Philharmonic Factory Wiring Error?	30	Dec 10, 2014 Reply by Joe Miller
"Norm, I looked (using magnification) at the schematic (Riders Page 14-49 under Scott…" Joe Miller replied Dec 6, 2014 to Philharmonic Factory Wiring Error?	30	Dec 10, 2014 Reply by Joe Miller

‹ Previous
1
…
10
11
12
13
14
…
20
Next ›

Welcome to
EH Scott Radio Enthusiasts

Sign Up
or Sign In

© 2025 Created by Kent King. Powered by

Badges | Report an Issue | Terms of Service

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use EH Scott Radio Enthusiasts.

Please check your browser settings or contact your system administrator.

Sign in to chat!