EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

Joe Miller's Discussions (239)

Discussions Replied To (197) Replies Latest Activity

"Jeff, Thanks for your suggestions. 1. I think I can make this work by pushing down o…"

Joe Miller replied Jan 26, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"Well, I found one more glitch.  The set plays great now.  I installed the new dial g…"

Joe Miller replied Jan 26, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"Thanks for the tips guys. I think I have some bass control now. It is going in a sol…"

Joe Miller replied Jan 24, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"Fixed. It was one of the 6J5s located in the 1AF position.  The tube tests very good…"

Joe Miller replied Jan 24, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"This thing is kicking my rear.  All done, alignment complete, sounds good except for…"

Joe Miller replied Jan 23, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"Scott, If you have time would you check your bass control for me?  I need to verify…"

Joe Miller replied Jan 22, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"Scott, Great idea, I'll see if I can figure out how to upload a video from my Samsun…"

Joe Miller replied Jan 20, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"Hi Ken, I just completed this same repair. Be sure to check your bass control pot (i…"

Joe Miller replied Jan 20, 2015 to How do I remove cover of bass choke on Philharmonic?

11 Jan 26, 2016
Reply by Ken Carr

"Well, I am back in business.  Have full volume now.  After much searching I found tw…"

Joe Miller replied Jan 20, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

"VRE eye tube works fine now (it was the bad 1 Meg resistor) VRE system works I reins…"

Joe Miller replied Jan 18, 2015 to Philly Loose Ends during Startup

50 Jan 28, 2015
Reply by David C. Poland

RSS

© 2025   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service