The Fine Things are Always Hand Made
Forum Discussions (1,174)
| Discussions | Replies | Latest Activity |
|---|---|---|
800B FM IF Resistor & Capacitor IssueToday while working in the FM If strip of my 800B, I looked at R68 marked as a 39K ohm resistor. Its value had increased to almost double i… Started by Joseph W Strickland |
7 |
Feb 15, 2017 Reply by Joseph W Strickland |
Scott Masterpiece SchematicJust picked up a Masterpiece and need a good schematic. Anyone know where I can find one that is legible? Thanks, Joe Started by Joe Miller |
5 |
Feb 14, 2017 Reply by David C. Poland |
800B Escutcheon Panel DifferencesSince I have both the Early and the Late radio tuner chassis of the 800B, I took note of some differences in their front escutcheon panels.… Started by Joseph W Strickland |
5 |
Feb 14, 2017 Reply by Joseph W Strickland |
800B with Wired Remote OptionThere is currently an 800B radio-tuner chassis on eBay that has the very rare wired remote option. You can spot the removed cover plate in… Started by Joseph W Strickland |
3 |
Feb 13, 2017 Reply by Joseph W Strickland |
Some 800B Service Manual DiscrepanciesI discovered some 800B Service Manual Discrepancies today. In comparing what was in the AM RF compartment versus the schematic for the Earl… Started by Joseph W Strickland |
1 |
Feb 13, 2017 Reply by Joseph W Strickland |
Allwave 23, 7-knobAfter many years, I'm beginning the process of resurrecting my Scott. The 7-pin plug that goes on the end of the cable that goes between th… Started by Jeff Barna |
15 |
Feb 13, 2017 Reply by David C. Poland |
allwave fifteen voice coilhi, can anyone help with the voice coil impedance on an allwave fifteen, the cone has been removed but the spider and a badly damaged voice… Started by mike hadley |
8 |
Feb 12, 2017 Reply by mike hadley |
Wanted: tube Caps for McMurdo Silver MS 6Need 2. These were tops to a 2 piece tube shield but not sure if same were used on earlier models? Started by Dave |
0 | Feb 11, 2017 |
Speaker Cabinet DoneToday I finished putting together the speaker cabinet I have been working on for my 800B. I had decided to go with this approach using a cu… Started by Joseph W Strickland |
20 |
Feb 10, 2017 Reply by Joseph W Strickland |
AM-FM Philharmonic Bias voltage stripDuring the restoration process of my AM-FM I noticed, rather late, a 500 ohm power resistor on the -27 v tap of the bias resistor strip to… Started by Tom Jardine |
4 |
Feb 9, 2017 Reply by Tom Jardine |
© 2025 Created by Kent King.
Powered by
