EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

Lou deGonzague's Discussions (9)

Discussions Replied To (8) Replies Latest Activity

"Update to old post, I did have a NOS control and installed it in the set at the owne…"

Lou deGonzague replied Sep 20, 2022 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

"I installed the radio back in the cabinet a couple weeks ago and thought everything…"

Lou deGonzague replied Jan 24, 2015 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

"That's good to know, I thought a coil would be very hard to find!  Here is a pic of…"

Lou deGonzague replied Jan 10, 2015 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

"Taking a close look for a mis-wire I discovered no continuity to plate of 6B7.  Afte…"

Lou deGonzague replied Jan 9, 2015 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

"Well, I tried that adjustment but there was no effect when turning the  adj. screw o…"

Lou deGonzague replied Jan 8, 2015 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

" I used 2 pieces of plywood screwed into the bottom plate hole"

Lou deGonzague replied Jan 4, 2015 to How do you support your Scott chassis while working on it?

21 Sep 15, 2017
Reply by David Wilson

"Thanks Norman, I'll make that adjustment.  i think this will be the last thing to do…"

Lou deGonzague replied Jan 4, 2015 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

"So, this is a wave trap for preventing RF signals at 465 from entering the IF just l…"

Lou deGonzague replied Jan 3, 2015 to Allwave 23 RF diode adjustment

12 Sep 20, 2022
Reply by Lou deGonzague

RSS

© 2024   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service