EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

I have recently acquired from Norman a Philharmonic Regent cabinet (rare two piece cabinet) which I understand was purchased from Kent King.  The front panel is missing and so is the speaker baffle. I am now busy making the front panel but I am missing the panel hardware.  I do have a bezel and wood knobs but that's it.  I need the tuning "eye lids" and knob escutcheons.

Views: 37

Reply to This

Replies to This Discussion

Eye lids - plural?  so you have the 28 tube FM Phantom Deluxe with two magic eyes?

I can offer 1 or 2 of the correct square eye escutcheons. PM me if interested.

Also, for the front panel, be sure you are using 3/8" plywood or less (no thicker) so the shafts extend sufficient with escutcheons for the knob set screws to grab the control shafts.

For the speaker board, at least 3/4" plywood, or if you are really ambitious, glue up 1 inch thick spruce boards to the needed width.

Yes I have a 28 tube FM phantom deluxe.  Need 2 square eye escutcheons.

David C. Poland said:

Eye lids - plural?  so you have the 28 tube FM Phantom Deluxe with two magic eyes?

I can offer 1 or 2 of the correct square eye escutcheons. PM me if interested.

Also, for the front panel, be sure you are using 3/8" plywood or less (no thicker) so the shafts extend sufficient with escutcheons for the knob set screws to grab the control shafts.

For the speaker board, at least 3/4" plywood, or if you are really ambitious, glue up 1 inch thick spruce boards to the needed width.

Reply to Discussion

RSS

© 2024   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service