EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

Norman S Braithwaite's Discussions (848)

Discussions Replied To (839) Replies Latest Activity

"Joe: Here's a third version that is rather crudely made and has been modified with a…"

Norman S Braithwaite replied Feb 14, 2017 to 800B Escutcheon Panel Differences

5 Feb 14, 2017
Reply by Joseph W Strickland

"I don't recall ever finding a 2-meg resistor in that location.  I do recall finding…"

Norman S Braithwaite replied Feb 12, 2017 to Allwave 23, 7-knob

15 Feb 13, 2017
Reply by David C. Poland

"At what frequency did you calculate the impedance?  I am not sure but I think that 1…"

Norman S Braithwaite replied Feb 11, 2017 to allwave fifteen voice coil

8 Feb 12, 2017
Reply by mike hadley

"The 500-ohm resistor was used to bring the bias voltage into compliance with the cir…"

Norman S Braithwaite replied Feb 9, 2017 to AM-FM Philharmonic Bias voltage strip

4 Feb 9, 2017
Reply by Tom Jardine

"Are you injecting the signal to the grid of the converter? If injecting to the grid…"

Norman S Braithwaite replied Feb 8, 2017 to Scott Masterpiece alignment

4 Feb 9, 2017
Reply by Kent King

""

Norman S Braithwaite replied Feb 8, 2017 to Scott Masterpiece alignment

4 Feb 9, 2017
Reply by Kent King

"Tom: The general consensus of collectors in the know is that the IF strip of the Phi…"

Norman S Braithwaite replied Feb 8, 2017 to Speaker Cabinet Done

20 Feb 10, 2017
Reply by Joseph W Strickland

"Can you post a link?  I cannot find it. Norman"

Norman S Braithwaite replied Feb 8, 2017 to 800B with Wired Remote Option

3 Feb 13, 2017
Reply by Joseph W Strickland

"Joe: Yes, some were paper in oil capacitors.  Usually these ones were marked "oil" o…"

Norman S Braithwaite replied Feb 4, 2017 to 800B FM IF Resistor & Capacitor Issue

7 Feb 15, 2017
Reply by Joseph W Strickland

"Good point!"

Norman S Braithwaite replied Feb 3, 2017 to AM FM Phantom on eBay - non Scott tweeters?

16 Feb 4, 2017
Reply by Tom Jardine

RSS

© 2025   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service