EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

I have my Allwave 23 sitting next to a couple other radios, found this tag on the floor, belong to the Scott?  If so where might it have been stuck?  I don't see any places inside of the cabinet where this might have been.  Also just starting to mount the receiver into the cabinet.  Since this receiver was not bolted from the bottom how do you know when it is pushed forward enough?  Stop when it is close to the inside front of cabinet, or should there be some sort of spacer, or stops on the various adjustment shafts?  Thanksthumbnail.jpg

Views: 55

Comment

You need to be a member of EH Scott Radio Enthusiasts to add comments!

Join EH Scott Radio Enthusiasts

Comment by todd landis on May 23, 2020 at 8:18pm

Think so on a plate on bottom of chassis.  Think will just put in plastic bag with piece of cardboard to try to save. 

Comment by Kent King on May 23, 2020 at 7:52pm

That tag goes on the smaller, inner plate over the wave change coils. It is under the larger, full chassis bottom plate. Hope that makes sense.

© 2024   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service