EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

All,

I just bought an AM/FM Phantom from Estes this last weekend.  It has been overhauled and is getting set to become a daily player.  I have an AM/FM Philharmonic that has the tweeters and crossovers that my AM/FM Phantom is not equipped with.  Can I use them with the Phantom, or are they different for each radio?  Once I get the Philharmonic overhauled, I'll probably put everything back together, but, until then, it would be nice to be able to use them.  

Views: 57

Comment

You need to be a member of EH Scott Radio Enthusiasts to add comments!

Join EH Scott Radio Enthusiasts

Comment by David C. Poland 12 minutes ago

Alex - looks right.

Now you know what to look for in the event you decide to seek another multi unit speaker set for the other FM Scott. Be crossover version with the Jones plug on the Amp cable. And a choice on crossover type, either 1) no rectifier tube and PM tweeters having small 2 pin plugs ... or 2) rectifier tube on the crossover and field coil tweeters with small 4 pin plugs.

IMG_0711.JPG

Comment by Alex R. Whitaker 20 hours ago

The plug for the tweeters is round, also as you described. 

Comment by Alex R. Whitaker 20 hours ago

I went and took a picture of the plugs on the Philharmonic crossover.  The plugs are as you described.  The tweeters plug into the back of the crossover.  

Comment by David C. Poland yesterday

Because both FM version models have Jones plugs, , then the only issue involves whether your crossover has an a 2nd cable with small 4 (or 5) pin plug. 

I think the optional 4 unit hifi speaker system was intended for FM models only.  Jones plug cabling indicates 1941 or perhaps early 1942 production and ,so, I would expect both of your FM sets have little  a simple terminal strip for phono input and a small rear apron 4 pin (or 5 pin) socket for  a second crossover cable. Therefore, I think your speaker set is "plug and play" for either radio. 

Comment by Alex R. Whitaker yesterday

Dave....that is interesting.  I finally figured out where I'm going to put the AM/FM Phantom in my showroom, so it can now come into the house and I can examine it further.  I know the Philharmonic has Jones plugs that connect everything, and so does the AM/FM Phantom.  I don't remember seeing a little socket on the Phantom, but will look again as I'm moving it in.  The guy that restored the radio had a note that said he didn't re-cap the FM section, as it was obsolete.  However, I bought one of the Scott FM adapters from Kent that I will be using with the Phantom, so I will have to rebuild that section of the radio.  I'm going to do like Kent suggested, and check out the wiring to the Philharmonic's speaker system.  If it is compatible, I will use it with the Phantom until I rebuild the Philharmonic, which will hopefully be this winter.  Then, the Phantom will have to go back to one speaker.  Did you see the knob on one end of the cross-over, in the pictures I put on the post?  I'm guessing that changes the crossover frequency as it pertains to the tweeters...is that correct?

Comment by David C. Poland on Saturday

Alex, looking at your photos again, you seem to have a transitional crossover between the types 3 and 4. I see the jones plug on a cable. . and I see the location where the rectifier tube would be, but see a filler plug in that hole. Unclear if your crossover has that 2nd cable to the receiver, but suspect it does. 

if you Phantom is a Deluxe with old FM band and the amp speaker socket is Jones type, then maybe it has the little socket  wired to a band switch wafer, in which case the tweeter should operate. Otherwise, the tweeters will be silent, unless you make some careful modifications to the crossover.

Earlier production Phillys and Phantoms had the little socket wired for phono. If your Phantom has separate phono terminal screws, then the little socket is likely for the second crossover tweeter cable.

But as usual, Scott was custom set builder, and exceptions occur. Suppose for example,  the Philly was ordered with standard speaker and owner later decided to up grade to the optional hifi speaker system and Scott had to dumb down the crossover to make it work on that particular receiver.

Comment by David C. Poland on Wednesday

yes, depending on the cable plugs, and couple other issues including how your receivers are wired.

Here is my take.

Scott seems to have changed to Jones plugs for the Philharmonic and Phantom Deluxe sometime 1941, about the time the  1941 AM/FM/SW Scott Laureate was introduced using Jones Plugs for set and speaker cables. Be extremely difficult to covert Jones plug wiring to round plug wiring or vice versa. Be a bitch finding proper plugs. The Jones plugs included a jumper for AC to the power switch, now part of the volume control. I have had my hands on the Jones Plug example FM Phantom and have a 1941 Scott Laureate.

All 3 radio models used 6L6 output tubes (pair or a quad)) and the same standard speaker with tapped field, either 12 or 15 inch and there is every indication the STANDARD  speakers were electrically the same. Now, NO provision for optional tweeters like the Philly 15 inch pedestal did. Even a flange mount 15 inch speaker  for the Philharmonic towards 1941 became standard.

The optional multi unit high fidelity speaker systems introduced  in 1940 required a different big speaker, meaning the standard speaker with attached output transformer could not be used with it,

I have observed 4 iterations of the crossover. Every version has the output transformer in the crossover. The larger speaker was a woofer and the each tweeter had its own 2 pin plug to the crossover. There was also a dummy plug wired as a jumper that could be rewired to feed a remote speaker. Riders has extensive information and diagrams of the crossover (See The Scott Laureate for Jones Plug version crossover wiring.)

1) larger crossover came first. Wired so the tweeters were always "ON". Round Amp plug.

2) smaller more modern looking crossover, wired like #1. Round Amp plug. Tweeters always "ON". 

3) smaller more modern looking crossover. Round Amp plug. Additional small cable with small 4 pin plug that fits small socket on receiver rear apron. this small socket is no longer for a phono, Now it is connected to an additional wafer on the band switch, wired so the tweeters only function on the high frequency FM band. (I rewired my Scott Laureate so it also functions on phono, for a CD player)

4). smaller more modern looking crossover, with an added rectifier tube. Jones Plug to receiver. Small cable to receiver to the band switch wafer to limit tweeter(s) to FM only. The tweeters each have field coils and so have 4 pin plugs (and look a lot like table radio speakers). My Scott Laureate has but one tweeter, coax style on the 15 inch woofer. 

*

I have a late 1939 remote control AM/SW Phantom Deluxe, to which I added the Scott optional hiFi speakers. I accumulated a type 3 crossover  which I rewired (removing the 2nd cable) so that the tweeters will always be 'ON". being earlier PM Jensen type, used red and black banana plugs that fit the crossover sockets and the colors to observe polarity. Picked up the proper 12 inch Scott woofer for it.

Comment by Kent King on November 10, 2026 at 3:46pm

Alex - OK, so the pictures you posted...if you use the entire setup - crossover and 3 speakers, you should be able to use them with the Phantom you got. As I recall, that Phantom has Jones plugs. If this crossover uses the Jones plug, just verify the pins are the same (output plates, fields, etc) and it should be an equal swap. If this crossover uses the older round plug, you will have to add a Jones plug to the crossover to connect to the Phantom PS. I may have a connector if needed on that. Let me know how it goes.

Kent

Comment by Alex R. Whitaker on November 9, 2026 at 10:21pm

I've posted views of the tweeters, main speaker, and crossover network.  It looks like I may have left a couple of mouse turds in the bottom of this thing by accident.  My apologies for that.  

Comment by Alex R. Whitaker on November 9, 2026 at 10:19pm

© 2026   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service