EH Scott Radio Enthusiasts

The Fine Things are Always Hand Made

Greetings Working on the AW23 tuner rebuild.

I replaced the grid cap wire on the ifs. Can I leave it a few inches longer and tuck it back in the can (Im using test probe wire its super flexible) or should they be as short as possible.

Also the condenser trimmers on the ifs have a lot of powdery oxidation.  Any suggestions on cleaning? was thinking of alcohol and a flux brush. Or should I just leave it alone? 

Thanks

John

Views: 25

Comment

You need to be a member of EH Scott Radio Enthusiasts to add comments!

Join EH Scott Radio Enthusiasts

Comment by John Perry on March 14, 2021 at 11:44pm

Thanks for the input . I am almost done with the tuner. Next I will do the power supply.

Comment by Kent King on March 14, 2021 at 10:33pm

John -

On the IF leads, I usually cut them so I only push back maybe an inch or so - a small amount won't hurt anything. 

I dust the moving parts with a very soft (camel's hair) brush, I don't use any solvent. However, Alcohol is probably fine.

Kent

© 2021   Created by Kent King.   Powered by

Badges  |  Report an Issue  |  Terms of Service