The Fine Things are Always Hand Made

Area of B Voltage Divider - How should wiring look?

The wiring in the area of my B voltage divider has a few problems.

A loose wire is connected to the 100 V tap. There may have been a replacement resistor attached to this (broke away early on). The B+250V terminal attaches to a 'blob' of solder (blob-right) that joins several wires. There is also another blob to the left that is not attached to the B divider but is just a floating connection for several wires.

If anyone has a photograph from the same perspective as mine (see below) please be so kind as to post it. I just need a little help in putting this area back together again. I realize that I will have to trace everything but a photo of the correct physical layout may be helpful.

Thanks!