The Fine Things are Always Hand Made
Looking for ideas - I haven't dug into this too far yet.
I recapped an AW23 (late) and I'm now working on the alignment. Voltage checks were in spec. IF alignment went right by the service data and trimmed out nicely. By the time I got back to the 1st IF, I had significantly reduced the generator output to keep the meter from going over - gain was excellent. On to AM band - 1400 trimmer is super close, slight tweak and then dial down to 600. At about 750, the two neon VR tubes…Continue
Added by Kent King on October 6, 2020 at 5:06pm — 8 Comments
© 2023 Created by Kent King. Powered by